heliblog

heliblog

RC Helicopter flying, RC Cars and RC boating

Made for other people and me to track what I am doing when with my remote controlled units. It started out with helicopters. Hence the name.

If only one of my units is of interest, this unit can be clicked on the right and only posts regarding that unit shows up.

This blog is open for comments so feel free to leave a comment.

Möwe update

Robbe MöwePosted by xilsoe Jul 30, 2011 14:39:33
Today I got the receiver for Möwe. A Spektrum MR200. I was expecting it to be waterproof like the MR3000 as it is a marine receiver, but it seems to be only splash proof, so I should probably secure it further against water.

Further some words on the electronics I have chosen.

I decided to buy a Graupner brushless ESC along with the boat: Best-Nr: 7232. It is designed for up to 4S LiPo and 18A. The BEC delivers 5,5V and 2A. I programmed it today. It seems to be a nice ESC, comparable to the Robbe ROXXY 9XX series. As the motor rotation can be reversed, I am thinking of soldering the motor wires to ESC. This means lighter weight and eliminates connector failures.

For battery I am going to use LiPo. I have some small 2S and 3S.

I also have a Robbe/Futaba S3106 servo lying around. That might go in. Otherwise I might use one from my Lama heli.

As it can bee seen in the pictures below, I started painting. The chosen red colour is Revell 322.

smiley

  • Comments(0)//heliblog.moller-ilsoe.dk/#post293

Pictures of Möwe construction

Robbe MöwePosted by xilsoe Jul 26, 2011 09:07:12
I made some progress on my new Möwe. Some parts ordered needed to complete it that I am waiting for.

Here are some pictures from yesterday:

smiley

  • Comments(0)//heliblog.moller-ilsoe.dk/#post292

Robbe Möwe arrived

Robbe MöwePosted by xilsoe Jul 24, 2011 13:37:51
Yesterday I went to the local mail office to check whether they got my Robbe Möwe. They got it but for some reason I didn't get a note. Lucky I went and checked smiley

This seems to be a nice little kit that can be built in a week or two. I don't think it will be long before I am done. For some reason Robbe has included a 30mm propellor. I don't understand why they think that's a good idea. 20mm or 25mm will probably be much nicer to the motor.

Once again I'll be using a brushless outrunner. A small 28mm at 1500KV. That should give me the torque I need.

Pictures of the motor:

smiley

  • Comments(0)//heliblog.moller-ilsoe.dk/#post291
« Previous